Flat Cut Letters Installation

Flat Cut Plastic Letters Installation Methods

Stud Mount: Installation patterns are used with stud installations. Provided at additional cost of $2.50 per letter. Patterns indicate with little dots ● ● ● where to drill (best into mortar joints, hammer drill preferred) your holes on the mounting surface. Studs are supplied and attached to the back of the letter after receipt. Insert the studded letters into the holes you've drilled & cleaned out, using silicone to secure.

Materials & tools may include: Letters, Installation Template or Spacing Tape, Turkey Baster or Compressed Air, Bolt Cutters, Wrench, Studs, Nuts and Washers (or pads), Shims, Masking Tape, Silicone Adhesive, Drill and Bits, Safety Glasses, Shop Brush, Level and Ladder.

Click Images Below for Enlargements

1A-PLAIN	2A-STUD	2B-PAD	2C-COMBINATION	2D-COMBINATION ALL	2A-FLUSH STUD

Mounting Variations:

	Plain Mount is no mounting hardware. Add 40% for double-stick tape on flat cut and laminated MetalFaced. Tape IS included in the price for MirrorFaced.

	Stud Mount is a 3/16" diameter 10-24 stud coming out the back. You can request spacers to allow your letter to stand off the mounting surface. Indicate how much standoff you would like. Pattern Needed.

	Pad Mount is a clear plastic pad in which you apply clear silicone adhesive and tape the letter up (6-12 hours) until the silicone dries.

	Combination Mount is a stud going through a pad on the top half of the letter & a pad mount on the bottom half. You drill a 1/4" diameter hole to accommodate the stud. Fill hole with silicone and silicone the pad to the surface. Pattern Needed.

	Combination All Mount is a stud going through a pad on all locations. You would drill a 1/4" diameter hole to accommodate the stud. Fill hole with silicone. Pattern Needed.

	Flush Stud Letters must be at least 3/8" thick for this method. Thinner letters either A) Glue directly to your surface. OR B) Have a stud mount pad/block glued to the back.

	How to install:
	Verify all boxes and letters have been delivered before the installation.
	Check installation template (mounting pattern) before the installation.
	Center and level then tape template on mounting surface.
	Drill 1/4" holes 3 inches deep where indicated on the template.
	Remove Template, then Blow all debris from holes after drilling.
	Insert the studs into the stud holes on the back of each letter.
	Apply silicone to the studs. Push studded letters into drilled holes.
	Make sure number on back of each letter matches positioning on template.
	Use only top quality materials (silicone, tape, etc.).